Replace the fuel in the gas tank if the fuel is older than 3 months. pressure washer won't start unless trigger is depressed . 6. Mechanical Issues and Improper Use: There are times when engine parts on your washer can break. Whenever the latch or one of the other key components fails, your washer won't start or continue the cycle. The relief valve on the pump looked bad so I replaced it. If you want to upgrade your rope to something stronger then take a look at this True Blue Starter Rope. Find solution. Still a very hard pull . Required fields are marked *, Get The Latest Updates Delivered To Your Inbox. Find solution. New development: I started the washer and then turned on the water. The damage will be immediate and devastating to the pressure washer’s inner workings. Checked for oil…it’s ok, the level is good and there is no hydrolic lock or anything that I could tell. A gorilla could probably start it if the rope didn’t break first ! In a front-load washer, the lock assembly features a latch and locking mechanisim, and it also has a safety switch to detect whether the door is open or closed. A pressure washer unloader valve prevents the pressure from building to the breaking point when you aren't spraying water. Pressure Washer Won’t Start After Sitting. Visit us at: http://www.apwdistributing.com/Today, we're going to teach you how to properly setup and start your pressure washer. Now, with your washer running, the real fun begins!Music: \"The Wire\"Kevin MacLeod (incompetech.com)Licensed under Creative Commons: By Attribution 3.0http://creativecommons.org/licenses/by/3.0/ If you have difficulties at starting up the engine, here are three of the main causes – as well as the solutions that you may try on them. It is easy to clean, flexible, and strong while still being affordable and looks good too. Make sure you watch where you are pointing the wand as it starts up. Chris (aka - Moose), Technician. As the cleaning continues the “start” pressure switch opens up. If you want to avoid the common issue of having a pressure washer that is hard to pull you must do these simple steps when starting it up every time. A flaw in the switch could mean that the water inlet valve doesn’t get turned on. What To Do If Pressure Washer Is Smoking? Click to remove this tagging. There must be water flow through the system for the unit to turn on. Now, you'll want to turn the throttle up to rabbit speed and not turtle speed, sliding the switch away from you is how you turn the throttle up on most models. No blockages I can see. If you haven’t really dealt with a pressure washer before, then you’ll need some instructions on what to do when a pressure washer stalls under load. For most pressure washers you will turn the power switch to on. If your gas-powered pressure washer engine does not start or is lacking power, there are a few things you can do. Hotsy pressure washer is not turning on, is not supplying water under sufficient pressure, is not working or is not heating the water – breakage can be any. With your garden hose hooked into the pressure washer and turned on, pull the trigger on the wand to see if the water is coming out of the rod. Pressure Washing Guides and More. 7 possible causes and potential solutions . Pressure washers are manufactured in two basic types: gas-powered and electric-powered. Now you are ready to start the pressure washer. Water leaks from within the washer. Pulling the trigger will also work if you forget to at first and your starter rope becomes hard to pull. Ask Your Own Small Engine Question . After you have your washer started, flip the choke switch back to the OFF position in order to get your engine idling properly. If the spark plug has suffered from too much wear and tear, or is just very damaged, you will have to replace it. Even if it’s not running, turn the switch to the “off” position. The wash cycle won't start if the direct-drive washer doesn't fill or the water-level pressure switch doesn't detect that the washer filled.