Mechanic tells me that code pulled up a power issue with Master Module, issues with side airbags and issue with passanger seat. So, I bought the new part from Pacific BMW and replaced it. 2000 Bmw Z3 Air Bag Lite On/evap Fault Code Problem 1-air Bag Lite On, Bavauto(peake? You cannot reset this light with a generic obd2 scanner. from good ole ebay..note to others i had to use the extension supplied and plug into terminal on engine and it worked just fine..didnt work on the terminal under the steering wheel though.
As I am trying to do most of the repairs myself, he told me to start by testing master module. There must be a problem with the air bag system for the light to be on, if the system was o.k.
hi. A BMW specific tool that can reset the airbag is required to reset the light. It can only be reset with a tool. 2000 BMW Z3, Airbag light on. I purchased a "reset" oil change tool to plug into the round BMW reset block undeR the hood but that will not reset the airbag light. BMW airbag light no codes. BMW did produce a wiring mod which basically extended the wire so it could be re-routed out of the way but with some simple wiring additions this can be done yourself. Connect BMW B800 with BMW Z3 using the round 20 pin connector. No. I then attached the 20-pin connector and plugged in under the hood. Dealor said it has something to do with the active seatbelt resraints and it is expensive to fix. Share. Can reset BMW airbag light by disconnecting the battery? Simply press the Enter button (upper one) and it read out BMW Z3 airbag light fault code: “01”. BMW airbag light no codes. Good Luck. Tips on car buying, how to negotiate, and how to buy a car. Press the “Scroll” button (lower one) to stop. Reset it and see if it comes back on. Nothing is wrong with the airbag system as I caused the light to come on. When BMW B800 is connected successfully with car, it will automatically power up and show “FA”. And I must pay the money or live with the light on.
BMW B800 Airbag Reset Tool Function 1pc x B800 Interface.
The light will typically come on after you move the seat if this is the problem.
1 x B800 SRS Scanner And Resetter Tool for BMW.
the light would be off and have a stored code. )Air Bag Scan/reset Tool Shows"table 03-code 02"'firing Circuit, Belt Tensioner, Drivers Side. Generic OBD2 code readers are not capable of reading BMW airbag codes. These are codes stored in the airbag control module. Q 1997 M3 I was wondering if you might know what would cause the light to come on other than the pad in the seat. Make sure to use a BMW specific scanner.
This answer is applicable for many BMWs in addition to the one listed below. As I am trying to do most of the repairs myself, he told me to start by testing master module. my husband and i recently purchased a 1998 BMW Z3 with 90,000 miles. The system needs to be checked, incase there is a wire shorted, sensor bad or (as BMW TSB) Broken or Cracked circuir Board in the Belt Buckle. Hey all, After Inspection II on my 95 M3, I was told my SRS/airbag light was on due to a faulty passenger seat belt buckle. BMW Reset Tool List R5/FCX3 Fault Code BMW Reset Tool (1987-2000 BMWs) R5/FCX3-16 Fault Code BMW Reset Tool (2001-2006 BMWs) R5/FCX3-U (Combo) Fault Code BMW Reset Tool (1987-2006 BMWs) R5B & R5A Oil Service & Inspection BMW Reset Tool BMW Airbag Tool
When BMW B800 is connected successfully with car, it will automatically power up and show “FA”. the light would be off and have a stored code.