Torque Table The following suggested tightening torques provide an excellent starting point for determining torque requirements. This International Standard specifies the conditions for carrying out torque/clamp force tests on threaded fasteners and related parts. Includes: M5E1 Handguard Barrel Nut
This product comes with 5 shims to properly time the gas tube with the upper receiver. The M5E1 Handguard Barrel Nut is used to connect Aero Precision M5 Enhanced Handgaurds to DMPS pattern threaded upper receivers.
Remember, you may need to vary these numbers somewhat based on the individual joint or the amount of fastener lubrication. 4 POCKET GUIDE TO TIGHTENING TECHNIQUE This booklet provides an introduction to the technique of us-ing threaded fasteners for assembling components, the ap-plication of power tools for the assembly and the influence of tool selection on the quality of the Required torque for M4 and M5 stainless steel bolts into aluminum part You will have to register or login (See top or bottom of page) before you can post a message or view images: click the appropriate link to proceed. Phone: 1-800-558-2808 • Fax: 1-800-553-8769 • www.imperialsupplies.com A55 FASTENER TORQUE CHARTS Imperial has made a concerted effort to provide accurate information in its catalog and on its web site, however Imperial assumes no responsibility 2 AZD00-02.frb 20/10/97 00 - General Instructions Type Screw Dimensio n Unit 00 00 M4 and M5 - maximum tightening torques in accordance with BMW N 600 02.0 Applicable range for tightening torques, refer to extract from company standard BMW N 600 02.0 Torque Settings Suggested Starting Values The below estimated torque calculations are only offered as a guide. It is applicable, basically, to bolts, screws, studs and nuts made of carbon steel and alloy steel, whose mechanical properties are specified in ISO 898-1 , ISO 898-2 or ISO 898-6 , having ISO metric threads with thread sizes M3 to M39.